bopssim.blogg.se

Man minicom
Man minicom










  1. Man minicom install#
  2. Man minicom serial#
  3. Man minicom software#

Note: Directories preceded with a period are “hidden” folders and should appear before all non-hidden folders. Minicom will now display a text based folder navigation, for example: Thus far you should see:Ĭopyright 1996 - 2005 Freesca+-+torĬTRL-A Z for help | 9600 8N1 | NOR | Minicom 2.3 | VT102 | Offline Then press Ctrl+A and press the S key for “upload”. To transfer a text file to the Dragon12 board, type in load in D-Bug12. You should receive the following D-Bug12 prompt:Ĭopyright 1996 - 2005 Freescale Semiconductor Note that it is unimportant if the device was connected before or after configuration.

Man minicom serial#

Once the Dragon12 is connected to the serial port, press the “reset” button on the board. Minicom is now 'listening' to the serial port (/dev/ttyUSB0 is the serial device is in this example). The following sequence should appear:įollowed by something similar to the following: Type minicom in a terminal to run Minicom. Selected Save setup as dfl (save setup as default) then select Exit from Minicom. When the configuration is complete you should be presented with the original screen. Press the 'Q' key for Data=8bits, Parity=none, and Stopbits=1 (8N1), these settings are required for the Dragon12 Board.Īfter the settings are set up correctly, press Enter to continue.Press the 'C' key for a baud rate of 9600bps.

Man minicom software#

| G - Software Flo| D: 38400 O: Mark V: 8 | | | F - Hardware Flo| C: 9600 N: Odd U: 7 | | | B - Lockfile Loc| Current: 9600 8N1 | | To edit the baud rate and related settings press the 'E' key.You should be presented with the following:

  • Press the 'G' key to toggle Yes or No.
  • Press the 'F' key to toggle Yes or No.
  • You should be greeted with the following screen: Next, select “Serial port setup” and press to continue. Now the following menu should be displayed: To start the configuration process type in the following command and switch: Now that Minicom is installed, the program must be configured properly to interface with the board. It would be best to use your distributions' repository if possible.

    Man minicom install#

    Minicom can be downloaded from Freecode or the following terminal command can be used to download and install the program:ĬAUTION: I've seen some potentially fake sites posing as the 'official' Minicom website with untrusted security certificates. This program is used from console to interface with D-Bug12 and send the text file to the board. Minicom is a serial communication program, which we can use with the Dragon12 board. Project maintained by Derrekito Hosted on GitHub Pages - Theme by mattgraham Introduction












    Man minicom